Makita 7104L Instruction Manual page 6

Adjusting depth of cut
Loosen the wing bolt on the stopper. Move
the stopper to the desired position and
tighten the wing bolt. When tightened, the
tip of the wing bolt should contact the flat
surface of the stopper pole. The numbers
indicated on the stopper pole are in cm
units (3 mm; 1/8" per graduation).
Securing tool
to
workpiece
Loosen the vise lever and move the rear
vise backward. Place the tool on the work-
piece so that the front vise contacts the
side of the workpiece. Move the rear vise
forward until the distance between the
rear vise and the workpiece is 3 - 8 mm
(1/8" - 5/16"). Tighten the vise lever to
secure the rear vise. Move the tool so that
the "0" on the indication plate is aligned
with the cutting line (A). Push the lever
Turn the setting handle until the front edge
of the yellow indicator plate is aligned with
the cutting line ( B ) .
6