Makita 7104L Instruction Manual page 5

Installing o r removing cutter chain
WARNING:
.Always be sure that the tool is switched off and unplugged before installing or removing
.Always close the chain cover after installing, removing
or adjusting the cutter chain.
the cutter chain.
Orient the cutters in the direction of the
arrow on the tool (rotational direction).
Attach the cutter chain to t h e sprocket first
and then
to
the chain bar. Semi-tighten the
hex bolt.
Turn the adjusting screw to increase the
tension o n the cutter chain. Pull the middle
of the cutter chain lightly. When there is
a clearance of approx. 5
--
6 mm W16"
-
1/4") between the chain bar and the cutter
chain, the tension on the cutter chain is
adequate.
After adjusting the tension, tighten the hex bolt firmly to secure the chain bar. Addi-
tionally tighen slightly t h e adjusting screw. Close the chain cover.
To remove the cutter chain, follow the installation procedures in reverse.
5