Welding A Tube Film - Silvercrest 304253 Operating Instructions Manual

Welding a tube film

NOTES ON THE FILM
► The film width may not exceed 30 cm . Otherwise it cannot be welded
correctly .
► Use only nylon-PE films with a structure (points or grooves) on one side and
that have a structure (points or grooves) on one side and a thickness of
approximately 0 .17 - 0 .29 mm (170 - 290 μ) .
Otherwise the weld seam will not be tight and the appliance may be da-
maged . You can recognise films of this type from the information on the
packaging . The quality of the weld seam will vary depending on the type
and thickness of the film .
► The supplied film is suitable for temperatures between -20°C and +110°C .
1) Cut the desired length for your bag from the tube film using a pair of scissors .
Cut as straight as possible .
2) Open the appliance lid 1 by pressing the lid release 8 and opening the
lid 1 upwards .
3) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5 . The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7 . If the bag lies over one or both of the two limiters 7, then the
bag cannot be correctly welded .
■ 8 │ GB │ IE │ NI │ CY SV 120 A1