Next steps
1. If applicable,
Install the M,2 BOSS
2. Follow the procedure listed in
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Removing the M.2 BOSS
4.
Remove the M.2 BOSS card from the M.2 BOSS
Steps
1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the connector on the M.2 BOSS card.
Figure 105. Removing the M.2 SSD module
Next steps
1. If applicable,
Install the M.2 BOSS card into the M.2 BOSS
2. If applicable,
Install the M,2 BOSS
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Removing the M.2 BOSS
4.
Remove the M.2 BOSS card from the M.2 BOSS
Steps
1. Align the M.2 SSD module at angle with the connector on the M.2 BOSS card.
2. Insert the M.2 SSD module until it is firmly seated in M.2 BOSS card connector.
riser.
After working inside your
Safety
instructions.
Before working inside your
riser.
riser.
riser.
Safety
instructions.
Before working inside your
riser.
riser.
system.
system.
riser.
system.
Installing and removing system components
103