Table of Contents
Advertisement
Steps
1. Locate the MicroSD card slot on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin end of
the card into the slot. To locate IDSDM, see the System board jumpers and connectors section.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the slot to lock it into place.
Figure 100. Installing the MicroSD card
Next steps
1.
Install the IDSDM
module.
2.
Install the air
shroud.
3. Follow the procedure listed in the
Optional BOSS S1 card
Removing the M.2 BOSS riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
Hold the blue touch points, and lift the M.2 BOSS riser from the riser connector on the system board.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
99
Advertisement
Table of Contents
