Table of Contents
Advertisement
3
Select [Basic mode], and click [Next >].
The following screen appears.
The receivers for which channel scan will be
performed will be displayed here for each frequency
band.
4
Click [Start scan].
Channel scan is performed, and the results are plotted
on the frequency spectrum display in the upper part of
the screen.
5
Click [Next >].
The following screen appears.
Candidate channel plans and the number of receivers
that can use the channel plans at the same time will be
displayed here for each frequency band.
6
Select the [Group type] to use for each frequency band.
Select the group type based on the device
configuration.
Sony preset GP [Digital system only]: Select this
when only Sony digital wireless systems are used.
Sony preset GP [With Sony analog system]: Select
this when the configuration also includes Sony analog
wireless systems.
Loaded from cpa file: Select this to use channel plans
that were selected during previous uses of [Channel
Plan Adviser].
User define: Select this to use user defined channel
plans.
7
Click [Next >].
The following screen appears.
The selected channel plan is assigned to the receivers
here.
8
Click [Auto].
The channel plan is assigned automatically.
Note
You can also assign channels one at a time by selecting
the receiver and frequency, and clicking the T button.
9
Click [Next >].
Configuration of the assigned channel plan starts for
the receivers.
If the receivers are already paired with transmitters,
the configuration is also sent to the transmitters.
The following screen appears.
10
If necessary, enable or disable [Reflect recommended
GP/CH], and then click [Finish].
[Channel Plan Adviser] closes.
If the [Reflect recommended GP/CH] checkbox is
selected, only the groups and channels recommended
by [Channel Plan Adviser] will be selectable on
Wireless Studio. The groups and channels
recommended by [Channel Plan Adviser] will be
displayed in the [Spectrum Analyzer] tab of the sub
window.
17
Advertisement
Table of Contents
