Calling Line Identification (Clip); Energy Saving Mode - Philips CRYSTAL 650 User Manual

²
With this setting, it is not necessary to enter
the outside line access code when you dial an
external number. The machine will automatically
add the outside line access code in front of num-
bers that are longer than the configured direct
dial numbers.
Æ
For older telephone systems, the outside line
access code can be (R) (also called FLASH).
Press PAUSE/R to enter the outside line access
code (R). Confirm with OK.
If (R) is indicated in your PABX as the outside line
access code but it is still not possible to obtain an
outside line, your system does not correspond to
the newest standard. If necessary, you may want
to ask your telephone system provider.
Calling Line Identifica-
tion (CLIP)
(Crystal 660)
For incoming calls, your multifunction machine shows
the number and name of the caller on the display. To
make use of this function, Calling Line Identification
Presentation (CLIP) must be enabled for your telephone
line. Contact your telephone company to inquire about
whether or not this additional function is available for
your line. Caller identification may be associated with
a fee. Contact your telephone company (depending on
country and network).
²
Your machine will display the name you have
saved for the subscriber in the machine's tele-
phone book.
The number and name will not be shown if the
caller suppresses his number.
If you receive a telephone call during your absence, the
symbol I will appear on the display. Your multifunction
machine saves the last ten calls in the redial list. You can
use the redial list for entering telephone numbers:
Press ³. A list of the last ten calls appears on the
1
display (marked by ').
Use / to select an entry. New entries are marked
2
with a star "*".
Start the message transmission as described in
3
the corresponding chapters (see chapter Fax,
Text2Fax, SMS, MMS).
Æ
If you have set the number of rings to zero
(0) (see chapter Fax Switch / Setting the
Fax Reception Mode), the telephone numbers of
callers will not be displayed on additional con-
nected telephones.
2. Settings

Energy Saving Mode

With the standard settings, your multifunction machine
switches to the energy saving Stand-by mode when not
in use. If you press any button or receive a message or a
call, your machine switches immediately from stand-by
mode to operating mode. Only in starting mode can
you enter information or access functions.
²
Crystal 660: The colour display illumination
is switched off in Stand-by mode to save
power.
21