Charging The Battery - Philips CT5888/000APMEA Manual

Hide thumbs Also See for CT5888/000APMEA:
Table of Contents

Advertisement

Charging the battery

Your phone comes with a standard battery. The
phone will emit an audible alert when the battery
reaches low. When the battery is completely flat, the
charging icon will appear after a few minutes of
charging.
We recommend that you do not remove the battery
when the phone is switched on as you may lose all your
personal settings as a result. If you do remove it, the
date and time settings are only memorized for a short
while. As such, you need to reset the information after
you have installed the battery back again.
Getting Started
1. Once the battery and back cover is attached to the
phone, plug the charger connector (supplied with
the phone, in the box) into the charging socket at
the base of the phone (arrow side up), and plug
the other end of the charger to an easily accessible
AC power socket.
2. The battery icon indicates the state of charge:
When charging, the 4 charge indicator bars
change constantly and it normally takes around
2.5* hours to fully recharge the battery (when
charging with the phone switched off, the screen
will display a charging animation).
3. When all 4 bars are steady, the battery is fully
charged and you can disconnect the charger.
Depending on the network and usage conditions,
the maximum talk time of a fully-charged
standard battery goes from 2 to 5 hrs*, while the
maximum stand-by time is about 300 hrs*.
*The data was derived from a test conducted at our
France laboratory when the battery is fully-charged
for the first time. Depending on the network
conditions, user settings, method of use, etc the actual
results may differ.
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

588

Table of Contents