TOOLS MENU
TOOLS MENU
On "Tools" menu, you can measure the coordinate of blade position or configure the radio.
RADIO DEVICE SETTINGS
For the settings of radio, see "METHOD FOR CONFIGURING RADIOS".
POSITION SETTINGS
METHOD FOR CHECKING BLADE ELEVATION
When checking the blade elevation, perform the following procedure.
1.
Press the power ON/OFF and menu switch to display the
main menu.
2.
On "Tools" menu, press "Position check..." and select.
3.
On "Position Check" screen, select "Point:".
Select the setting position of blade edge from "Blade: Left",
"Blade: Middle", and "Blade: Right".
4.
Press "Measure...".
After the measurement is finished, the coordinates of the
measuring point of the selected blade edge is displayed on
"Position Check" screen.
5.
Press "Save".
4-48
HANDLE CONTROL BOX
AJD02635
AJD02593