Table of Contents
Advertisement
Using the Boot Menu
Update Boot and Application
After making your changes in the fields above, press RESET DEVICE TO
START UPDATE to initiate the update sequence.
Each item on the Update Boot and Application screen is described below:
Software Update Mode: This specifies downloading the image file
through a WAN Link.
TFTP Server Address: The IP address of the TFTP server where the
runtime or configuration file is located. This entry is used only if the
Firmware Update is set to Enable.
Firmware Update: Determines whether or not the device will try to
look for a runtime image file on the TFTP server.
File Name: The complete path and filename of the runtime image file
on your TFTP server to be uploaded to the device.
Use Configuration File: Toggle to Enabled to use the settings in a
configuration text file when the device is reset (rebooted).
File Name: The complete path and filename on the TFTP server for
the desired configuration file.
Last TFTP Server Address: This is a read-only field that displays the
IP address of the last TFTP server to be accessed.
Note: After finishing the Update Firmware, you must perform a Factory Reset to
make sure firmware update is complete.
Save Changes
To save all the changes made in the current session to the device's flash memory,
use the <Tab> key to highlight the fourth menu item on the Boot Menu, Save
Changes, and press <Enter>. The Saving Settings screen will be displayed:
65
Advertisement
Table of Contents
