Fan Assembly; Removing The Fan Assembly - Dell Latitude E6400 XFR Service Manual

3. Connect the antenna connections to the RF Passthru board.
4. Replace the bottom access panel (see Replacing the Bottom Access Panel).
5. Follow the procedures in After Working on Your Computer.

10 Fan Assembly

10.1 Removing the Fan Assembly

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Follow the instructions in Before Working on Your Computer.
2. Remove the bottom access panel (see Removing the Bottom Access Panel).
3. Remove the three M2.5 x 5-mm screws that secure the fan to the base assembly.
Page 32
™
Dell Latitude™ E6400 XFR Service Manual
J5
J2
J3
J1 Black – WLAN (to WLAN card)
J2 Black/Red Sleeve – GPS (to GPS card)
J3 Black/Grey Sleeve – WWAN (to WWAN card)
J4 Black – WLAN (from LCD panel antenna)
J5 Black/Grey – WWAN (from LCD panel antenna
1 Fan 2 M2.5 x 5-mm screws (3)
J4
J1
2
1