5. Disconnect the LVDS cable from the motherboard.
6. Disconnect the antenna cables from the top side connectors (J4 & J5) of the RF Passthru board.
7. Remove the display gaskets using your plastic scribe. Use an in-out motion altering sides on an individual
gasket until the gasket is completely removed from the base. Once the gasket is pushed out of the base,
route the rest of the cables thru the chassis bridge to remove LCD cables and antennas from the base.
Page 45
™
Dell
Latitude™ E6400 XFR Service Manual
4
3
1
LVDS connector & cable
3
WLAN cable
J5
J4
Black – WLAN (from LCD panel antenna)
J5
Black/Grey – WWAN (from LCD panel antenna
2
WPAN cable
4
WWAN cable
J4
2
1