HP 510 Maintenance And Service Manual page 52

9. If it is necessary to replace any of the display assembly internal subcomponents, remove the
following display bezel screw covers and screws:
(1) Four round rubber screw covers on the top edge of the display bezel
(2) Four flat rubber screw covers on the bottom edge of the display bezel
(3) Eight Phillips PM2.5×6.0 screws
NOTE
part number DSCK-001. All screws used to secure display assembly internal
subcomponents are available in the Display Screw Kit, spare part number 404714-001.
10. Flex the inside edges of the left and right sides (1) of the display bezel and the inside edges of the
top and bottom sides (2) of the display bezel until the bezel disengages from the display
assembly.
11. Remove the display bezel (3).
NOTE
46 Chapter 5 Removal and replacement procedures
The display bezel screw covers are available in the Display Screw Cover Kit, spare
The display bezel is available using spare part number 440706-001.
ENWW