Base Enclosure - HP 510 Maintenance And Service Manual

Base enclosure

Description
Base enclosure
Before removing the base enclosure, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/Mini PCI card module compartment cover (see
c. Optical drive (see
d. Switch cover (see
e. Keyboard (see
f. Display assembly (see
Remove the base enclosure:
1. Release the ZIF connector (1) to which the TouchPad cable is attached and disconnect the
TouchPad cable (2) from the system board.
2. Turn the computer upside down, with the front toward you.
ENWW
Battery on page 29).
Hard drive on page 30)
Optical drive on page
Switch cover on page
Keyboard on page 40)
Display assembly on page
Spare part number
441625-001
Memory module on page
36)
38)
44)
Component replacement procedures
32)
49