Hitachi CP-SX12000 User Manual page 52

OPTION menu
Item
SERVICE
(continued)
52
REMOTE ID
Use the ▲/▼ buttons on the REMOTE ID menu to select ID and
press the ► button.
ALL ó 1 ó 2 ó 3 ó 4
The projector is controlled by the remote control whose ID button is
set the same number as this number. When the ALL is selected, the
projector is controlled by a remote control irrespective of the ID setting.
Selecting this item displays COMMUNICATION menu.
In this menu, you can configure the communication settings
of the CONTROL IN and the CONTROL OUT ports.
COMMUNICATION TYPE ó SERIAL IN SETTING
COMMUNICATION ID
COMMUNICATION GROUP
BYTES INTERVAL TIMEOUT ó RESPONSE LIMIT TIME
• Select an item using the cursor buttons ▲/▼. Then
pressing the ► button opens the submenu for the
setting item you selected.Or, pressing the ◄ button
instead of the ► button makes the menu back to the
previous one without changing the setup.
COMMUNICATION Each submenu can be operated as described above.
NOTE
COMMUNICATION menu are varied according to
the setup of the COMMUNICATION TYPE.
• For the function of serial communication, refer to
the Network Guide (Network Guide - 3.7, 3.8).
COMMUNICATION TYPE
In this menu, you can select
the communication type for
transmission from the CONTROL
OUT port.
NETWORK BRIDGE ó DAISY CHAIN ó OFF
NETWORK BRIDGE: Select this type, if it is required
to control an external devise as a network terminal, via
this projector from the computer. (Network Guide -
3.7 Controlling the external equipment via the projector
(using the NETWORK BRIDGE function))
Description


TRANSMISSION METHOD

• The selectable items on the

SERIAL OUT SETTING

