Battery Power; Recharging The Battery Pack; Replacing The Battery Pack - NEC VERSA 4000 Service Manual

Hide thumbs Also See for VERSA 4000:
Table of Contents

Advertisement

2-24
Setup and Operation
2.
Connect one end of the AC power cable to the AC adapter. Connect the other end
of the AC power cable to a 100- to 240-volt, AC wall outlet.

Battery Power

A fully charged battery pack lasts approximately up t o 5 hours with Power Management,
or 2.5 hours without Power Management.
When battery power is low, the battery outline on the battery status LCD blinks. If the sys-
tem speaker is enabled, three low battery warning beeps are emitted. The actual amount of
battery time depends on the use of power-saving features, the application, options installed,
and the environment.
Refer to "Battery Status" in the "Operating Controls" section for information on determin-
ing how much battery power is currently available.
When battery power is low, put your system in Suspend mode, remove the battery pack,
and replace it with a fully charged Li-Ion battery. Or, recharge the battery pack as follows.

Recharging the Battery Pack

To recharge the battery, leave the battery in the system and connect your NEC Versa to the
AC adapter and wall outlet. If you connect the system to the AC power and continue to use
it, the battery recharges in 2.5 to 7 hours. If you do not use the system while it is recharging
it takes about 2.5 hours.

REPLACING THE BATTERY PACK

To replace the battery pack with a fully charged battery, press the suspend button to acti-
vate Suspend mode. It is not necessary to turn off system power as long as Suspend mode is
activated. The bridge battery maintains data and system status for up to 5 minutes while in
Suspend mode. Use the steps below to install a charged battery pack.
If power is on, push the suspend button to put the system in Suspend mode. The
1.
bridge battery saves the memory contents and system status.
Turn the NEC Versa 4000 over so that it is upside down with the front of the
2.
system facing you.
3.
Remove the battery cover as follows:
T
Locate the battery cover latch and slide it towards the front of the system
T
Slide the cover about half an inch away from the system to align the cover
tabs and notches.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents