Table of Contents
Advertisement
Cable TV /VHF, UHF and CATV
I
f
---'h
_WER
SAP
_0
0
A_
)
U
ANTENNA
TERMINAL
ON THE
BACK OF THE PROJECTION TV
_l
POWER
o
D
D
G POWER
ON
LAMp
TEMP
Power switch
To Antenna
Input
® ®
OUTPUT
INPUT
Incoming
Cable from
Antenna
or Cable TV
System.
ODD
OD
CABLE BOX
Remote control sensor
Operation can be done
from the TV set.
• Volume adjusters
• Channel selectors
Cable TV
When the antenna cable is connected to the TV antenna
terminal via a cable box or VCR, set the TV channel to CH3
or CH4.
This does not apply when signal is input from VIDEO
INPUT.
Confirming
Confirm
that registration
with cable TV provider
and
connection of equipment are completed. Turn the CABLE
BOX on and select the desired volume level.
1
_2
Press _
to confirm.
Press while pointing
the remote control
towards the CABLE BOX.
Note:
The remote control code number is set for
Panasonic products.
When
peripheral
equipment
does
not
operate, reset code (See page 58 - 59).
3
Operate
the CABLE
BOX and select the desired
volume level.
VHF, UHF and CATV
Z/_
Press £/_
to operate the TV set with
1
the remote control.
2
Press to turn the TV on (See page 18,
lg).
3
Press
to select
the desired
channel.
Select the desired volume level.
Notes:
(1) The channel number and volume level remain the same
even after the TV is turned off.
(2) Power consumption and howls can be reduced if the
volume level is lowered.
17
Advertisement
Table of Contents
