Table of Contents
Advertisement
English
2. Insert the tab on the DM-D500 (or the
extension support) into the hole on the
DM-D stand as shown in illustration
70 until you feel it click.
3. Connect the cable for the DM-D500 to the display connector on
the DM-D stand as shown in illustration 71 until you feel it
click.
71
4. Connect one end of the computer interface cable to the
computer connector on the DM-D stand; then connect the other
end to the RS-232C connector on the computer as shown in
illustration 72. Tighten the screws on both ends of the cables to
fasten them.
computer
24 DM-D500 Installation Guide
72
70
Advertisement
Table of Contents
