[3] Transmittable documents
Refer to the service manual of UX-P100U.
[5] Quick setup guide
1
Connect the handset
and place it on the
handset rest.
5
Load the imaging film.
1. Open the operation panel (press
2
4. Insert the film into the print compartment.
6
Load paper.
The stack
should not
be higher
than this line
GENTLY LOAD PAPER INTO THE PAPER TRAY.
•
D O NOT FORCE IT DOWN INTO THE FEED SLOT.
•
Note: If you loaded legal paper, see page 16 of the
operation manual to change the paper size setting
to LEGAL.
2
Plug the power cord
into a 120 V grounded
outlet.
).
2. Remove the imaging film from its packaging.
1
Cut the band that holds the rolls together.
1
Fit ends of
rolls onto hubs
7
Insert the paper
print side down.
1. Press
2. Lift the handset, press
3. When finished, press
[4] Installation
Refer to the service manual of UX-P100U.
Note: To enter your name and fax number and set the date and time so that they
appear at the top of each fax you send, see pages 17 - 20 of your operation manual.
3
Connect the telephone
line cord to the TEL.
LINE jack and a wall
telephone jack.
5. Rotate the front spool as shown
until the film is taut.
Record an outgoing
message (greeting) for TAD
mode inviting callers to leave
a message.
(Note: ìTADî stands for
ìTelephone Answering
Deviceî.)
REC/
,
, and
.
MEMO
START/MEMORY
, and speak into the
handset.
STOP
.
1 – 3
4
Attach the paper tray
and document support.
3. Insert the green gears.
IMPORTANT: Do NOT discard the
green gears. They are not included
with replacement imaging film.
1 slot
Make sure
the gears fit
2 slots
into the slots
in the ends of
the rolls.
6. Close the operation panel (press
down on both sides to make sure it
clicks into place).
8
Select the reception mode for incoming faxes
and voice calls:
FAX mode: The machine automatically
answers all calls and begins fax reception.
TEL mode: Lift the handset when the machine
START/MEMORY
rings. Press
to begin fax reception.
TAD mode: Select this mode when you go out
to receive both voice messages and faxes.
(Note: To select TAD mode, you must first
record an outgoing message.)
TEL
JAN-01 10:30
RESOLUTION/
RECEPTION MODE
TEL
JAN-01 10:30
TEL
JAN-01 10:30
UX-A260U
Click!
Note: If the
support does
not go in,
turn it over.
FAX
TAD
The arrow in the
FAX
display points to
the selected
TAD
reception mode.
FAX
TAD