Kx-Tda And Kx-Taw Series Pbx Programming For Dpt Integration - Panasonic KX-TVA594 Installation Manual

4.2 KX-TDA and KX-TAW Series PBX Programming for DPT Integration

4.2 KX-TDA and KX-TAW Series PBX Programming
for DPT Integration
The screen shots shown in this section are for the KX-TDA200. Programming procedures and
availability may vary by PBX model, software version, etc. Refer to the documentation
included with the PBX or consult your dealer for more information.
A group of DPT ports of the PBX connected to a VPS with DPT Integration is called a "VM (DPT)
Group". Each VM (DPT) Group consists of a maximum of 12 ports (24 channels) of the VPS.
Up to 2 VM (DPT) Groups can be assigned for the KX-TDA100/TDA200; 2 VPSs can be connected
to a KX-TDA100/200.
Only one VM (DPT) Group can be assigned for the KX-TDA50 and KX-TAW series; in other words,
only one VPS can be connected to a KX-TDA50 and KX-TAW series.
Through PBX system programming, you must assign the VM (DPT) Group and the VM (DPT)
extension ports that will use DPT Integration.
1.
Assignment of VM (DPT) Group
a)
Go to the "Groups-VM (DPT) Group-Unit Setting" screen.
b)
Assign a floating extension number to the VPS (VM Unit number).
c)
Click "Apply" to save the changed data.
Note
•
Note
•
2.
Assignment of VM (DPT) extension ports
94 Installation Manual
For the KX-TDA100/KX-TDA200, you can use a maximum of 2 VM (DPT) groups (Unit
No.1 and Unit No.2).
All of the extension ports in a VM (DPT) group should be connected to the same DHLC
card or DLC card.
The screen shot above is an example of the KX-TDA200.