Cleaning The Monitor; Cleaning The Mouse; Service Considerations; Power Supply Fan - HP SignagePlayer mp8000r Maintenance And Service Manual

Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs Also See for SignagePlayer mp8000r:
Table of Contents

Advertisement

When cleaning debris from under the keys, review all rules in
on page 31
CAUTION:
under the keys.
Visible debris underneath or between the keys may be removed by vacuuming or shaking.
Canned, pressurized air may be used to clean debris from under the keys. Caution should be used
as too much air pressure can dislodge lubricants applied under the wide keys.
If you remove a key, use a specially designed key puller to prevent damage to the keys. This tool
is available through many electronic supply outlets.
CAUTION:
keys are improperly removed or installed, the keyboard may not function properly.
Cleaning under a key may be done with a swab moistened with isopropyl alcohol and squeezed
out. Be careful not to wipe away lubricants necessary for proper key functions. Use tweezers to
remove any fibers or dirt in confined areas. Allow the parts to air dry before reassembly.

Cleaning the Monitor

Wipe the monitor screen with a clean cloth moistened with water or with a towelette designed for
cleaning monitors. Do not use sprays or aerosols directly on the screen; the liquid may seep into
the housing and damage a component. Never use solvents or flammable liquids on the monitor.
To clean the monitor body follow the procedures in

Cleaning the Mouse

Before cleaning the mouse, ensure that the power to the computer is turned off.
Clean the mouse ball by first removing the retaining plate and the ball from the housing. Pull out
any debris from the ball socket and wipe the ball with a clean, dry cloth before reassembly.
To clean the mouse body, follow the procedures in

Service Considerations

Listed below are some of the considerations that you should keep in mind during the disassembly and
assembly of the computer.

Power Supply Fan

The power supply fan is a variable-speed fan based on the temperature in the power supply.
CAUTION:
off when the computer is in "Standby," "Suspend," or "Off" modes.
You must disconnect the power cord from the power source before opening the computer to prevent
system board or component damage.
32
Chapter 5 Identifying the Chassis, Routine Care, and Disassembly Preparation
before following these procedures:
Use safety glasses equipped with side shields before attempting to clean debris from
Never remove a wide leveled key (like the space bar) from the keyboard. If these
The cooling fan is always on when the computer is in the "On" mode. The cooling fan is
General Cleaning Safety Precautions
Cleaning the Computer Case on page
Cleaning the Computer Case on page
31.
31.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Signageplayer mp8000s

Table of Contents