HP SignagePlayer mp8000r Maintenance And Service Manual page 82
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
9.
Align the guide screws with the slots on the chassis drive cage, press the hard drive down into the
bay, then slide it back until it stops and locks in place.
Figure 6-45
10.
Connect the power and data cables to the back of the hard drive.
NOTE:
through the cable guide on the bottom of the chassis frame behind the hard drive.
If the system has only one SATA hard drive, the data cable must be connected to the dark blue
connector labeled SATA0 on the system board to avoid any hard drive performance problems.
11.
Rotate the drive cage for external drives and the power supply down to their normal positions.
12.
Replace the access panel.
13.
If the computer was on a stand, replace the stand.
14.
Reconnect the power cord and turn on the computer.
15.
Lock any security devices that were disengaged when the access panel was removed.
72
Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Installing the Hard Drive
When replacing the primary hard drive, be sure to route the SATA and power cables
Advertisement
Table of Contents
