Table of Contents
Advertisement
Recording From a Variable Frame-Rate Camera
Recording HD SDI output signals from a variable frame-rate camera as 720/
23.98p
Combined with a variable frame-rate camera (VariCam: AJ-
HDC27 series), the unit makes it possible to record HD SDI (720/
23.98p over 59.94p) output from the camera as DVCPRO HD or
AVC-Intra (requires optional board) 720/23.98p native recording.
Recording HD SDI signals from camera
output
1
Connect the camera HD SDI (720/23.98p over
59.94p) output to the SDI IN connector and press the
INPUT SELECT button to select SDI.
1
2
Make the following setup menu settings.
Item
No.25
No.020
No.040
◆ NOTE:
• To record 720/24p over 60p output from a variable frame-rate
camera, set menu No. 25 SYSTEM FREQ to 60-24. No output is
made to a monitor video in this mode.
3
Hold down the REC button and the STILL/PAUSE
button simultaneously to set the unit to REC PAUSE
mode.
4
To start recording, press the STILL/PAUSE button
while viewing the video output from the camera HD
SDI output.
◆ NOTE:
• Set setup menu No. 155 AUTO REC to TYPE1 and set the CONTROL
switch to REMOTE. The unit will then automatically start and stop
recording as the REC and STOP buttons are pressed on the
camera.
• SDI is output in the 1080/23.98 PsF video format. Analog video and
IEEE1394 are not output.
• The TIME CODE OUT connector does not output a time code and
no time code can be input to the TIME CODE IN connector.
3
4
• The SDI output is delayed relative to LCD monitor and monitor video
output. Analog audio, speaker and headphone output is
synchronized to the LCD monitor and monitor video output. To
synchronize these outputs to SDI output, set setup menu No. 778
AUD OUT DLY to ON.
• Set camera TCG to FREE RUN/NDF (non drop frame) mode. A TC/
UB of an SDI input that cannot be properly read cannot be normally
recorded.
Introduction: Recording From a Variable Frame-Rate Camera
Setting
SYSTEM FREQ
59-23
SYS FORMAT
720p
VFR REC
OFF
39
Advertisement
Table of Contents
