Using The Electronic Pen - Hitachi StarBoard FX-DUO-63 User Manual

StarBoard FX-DUO Series

2.2.2 Using the Electronic Pen

To use the electronic pen to draw characters or images, place the tip of the electronic pen on the
board and then move the pen. When you release the tip of the electronic pen from the board, the
writing is complete. Be careful of the following two points when using the electronic pen.
(1) When drawing with the electronic pen, keep the pen as perpendicular as possible to the board and
apply force sufficient enough to cause the pen tip to retract into the electronic pen.
(2) A miniature transmitter is embedded in the tip of the electronic pen. If you hold the transmitter
area of the electronic pen while drawing characters or images, the drawing data from the
electronic pen might not be transmitted correctly. If the characters or images drawn on the
whiteboard are not imported correctly into the PC, change your grip on the electronic pen and
then verify that they are displayed correctly.
Blocking of the Infrared Beam
Electronic pen operations are detected when the digitiser reads the infrared beams that are
generated by the pen. If the beam between the electronic pen and the digitiser is blocked,
normal input becomes impossible. Avoid blocking them during use.
2-5
How to Use
English