Epson AcuLaser CX16 User Manual page 196

This message...
USB Dev.Not support
USB Hub Not support
USB MEMORY FULL
Video I/F Error
WRONG PASSWORD
xxx Server
Wrong Toner x
xxx COVER OPEN
CLOSE xxx COVER
xxx IS DISABLED
xxxxx
IS NOT SUPPORTED
xxx SERVER ERROR
AcuLaser CX16 Series
means...
A USB device incompatible
with this machine is
connected.
A USB hub is connected to this
machine.
There is no space available on
the USB memory device
connected to this machine.
A video interface error
occurred in the machine.
The password is incorrect, so
the indicated server could not
be accessed.
An inappropriate toner
cartridge is installed.
The indicated cover is open.
The photoconductor unit is
not installed.
A photoconductor unit
incompatible with the
machine is installed.
The TCP/IP, FTP, SMTP or SMB
settings are disabled.
Repeat copying cannot be
performed with the specified
paper size.
The file cannot be saved on
the indicated server.
Printer / Copier / Scanner User's Guide
Do this...
Disconnect the USB device from
this machine.
This machine is not compatible
with a USB hub. When connecting
USB cables to this machine, do not
use a USB hub.
Delete data from the USB memory
device to create free space, or use a
different USB memory device.
Turn off the machine. After a few
seconds, turn on the machine.
Check the password, and then
specify the correct one.
Install only the toner cartridge
listed in "About Toner Cartridges"
on page 117.
Close the indicated cover.
Install the photoconductor unit.
Replace the photoconductor unit
with a correct one.
Enable the TCP/IP, FTP, SMTP or
SMB settings.
The maximum possible size for
repeat copying is A4.
Specify a paper size of A4 or
smaller.
Check the status of the indicated
server.
Troubleshooting 196