Dell PowerEdge M420 Administrator's Manual page 66

B
portCfgShow
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to
Admin Domain restrictions"
Operands This command has the following operand:
license
Examples To add a license key to the switch:
adding license-key [DXXtN3LmRSMWCSW3XmfSBPfrWKLZ3HMTN73rP9GANJMA]
portCfgShow
Displays port configuration settings.
Synopsis portcfgshow
portcfgshow [slot/]port
portcfgshow option [slot/] [arguments] [optional_arguments]
Description Use this command to display the current configuration of a port. The behavior of this command is
platform-specific; output varies depending on port type and platform, and not all options are
supported on all platforms.
"Non-GbE port displays"
If no operand is specified, this command displays port configuration settings for all ports on a
switch, except Gigabit Ethernet (GbE) ports.
Non-GbE port displays
The following information is displayed when the command is issued for all ports or for a specific
port:
Area Number
Speed
Fill Word
AL_PA Offset 13
Trunk Port
Long Distance
52
"Understanding Virtual Fabric restrictions"
on page 33 for details.
Specifies the license key to be installed. This operand is required.
switch:admin> licenseadd DXXtN3LmRSMWCSW3XmfSBPfrWKLZ3HMTN73rP9GANJMA
on page 52
Displays the port area number. This field is displayed only when portCfgShow
is executed for a specific port.
Displays Auto for auto speed negotiation mode, or a specific speed of 1, 2, 4,
or 8 Gbps. This value is set by the portCfgSpeed command.
Displays 0(Idle-Idle) or 1(arbff-arbff). This parameter is set by the
portcfgFillword command.
Displays (...) or OFF when the arbitrated loop physical address (AL_PA) on the
port is configured to use a 0x0 AL_PA address (default). Displays ON when
the address configuration is 0x13 AL_PA. This value is set by the portCfgAlpa
command.
Displays ON when port is set for trunking. Displays (..) or OFF when trunking is
disabled on the port. This value is set by the portCfgTrunkPort command.
Displays (..) or OFF when long distance mode is off; otherwise, displays long
distance levels as follows:
LE The link is up to 10 km.
on page 32 snf "Understanding
Dell 8/4Gbps FC SAN Module Administrator's Guide
53-1001345-01