Default Ospf Values - Dell PowerEdge M420 Configuration Manual

Default OSPF Values

OSPF is globally enabled by default. To make it operational on the router, you
must configure a router ID and enable OSPF on at least one interface.
Table 34-1 shows the global default values for OSPF and OSPFv3.
Table 34-1. OSPF/OSPFv3 Global Defaults
Parameter
Router ID
Admin Mode
RFC 1583 Compatibility
ABR Status
Opaque LSA Status
Exit Overflow Interval
SPF Delay Time
SPF Hold Time
External LSDB Limit
Default Metric
Maximum Paths
AutoCost Reference Bandwidth
Default Passive Setting
Default Information Originate
Non-Stop Forwarding (NSF) Support
(PCM6220 and PCM6348 only)
946
Configuring OSPF and OSPFv3
Default Value
None
Enabled
Enabled (OSPFv2 only)
Enabled
Enabled (OSPFv2 only)
Not configured
5 (OSPFv2 only)
10 (OSPFv2 only)
None
Not configured
4
100 Mbps
Disabled
Disabled
Disabled