Gvrp; Double-Vlan Tagging - Dell PowerEdge M420 Configuration Manual

Configuring the PVID for an interface is useful when untagged and tagged
packets will be sent and received on that port and a device connected to the
interface does not support VLAN tagging.

GVRP

The GARP VLAN Registration Protocol (GVRP) helps to dynamically
manage VLAN memberships on trunk ports. When GARP is enabled,
switches can dynamically register (and de-register) VLAN membership
information with other switches attached to the same segment.
Information about the active VLANs is propagated across all networking
switches in the bridged LAN that support GVRP. You can configure ports to
forbid dynamic VLAN assignment through GVRP .
The operation of GVRP relies upon the services provided by the Generic
Attribute Registration Protocol (GARP). GVRP can create up to 1024 VLANs.
For information about GARP timers, see "What Are GARP and GMRP?" on
page 718.

Double-VLAN Tagging

For trunk ports, which are ports that connect one switch to another switch,
the PowerConnect M6220, M6348, M8024, and M8024-k switches support
double-VLAN tagging. This feature allows service providers to create Virtual
Metropolitan Area Networks (VMANs). With double-VLAN tagging, service
providers can pass VLAN traffic from one customer domain to another
through a metro core in a simple and cost-effective manner. By using an
additional tag on the traffic, the switch can differentiate between customers
in the MAN while preserving an individual customer's VLAN identification
when the traffic enters the customer's 802.1Q domain.
With the introduction of this second tag, customers are no longer required to
divide the 4-byte VLAN ID space to send traffic on a Ethernet-based MAN.
In short, every frame that is transmitted from an interface has a double-VLAN
tag attached, while every packet that is received from an interface has a tag
removed (if one or more tags are present).
In Figure 21-2, two customers share the same metro core. The service
provider assigns each customer a unique ID so that the provider can
distinguish between the two customers and apply different rules to each.
When the configurable EtherType is assigned to something different than the
580
Configuring VLANs