Configuring Radius Server Information - Dell PowerEdge M420 Configuration Manual

Command
passwords strength
exclude-keyword
passwords strength-
check
exit
show passwords
configuration
show passwords result

Configuring RADIUS Server Information

Beginning in Privileged EXEC mode, use the following commands to add
information about a RADIUS server to the switch.
Command
configure
radius-server host [acct |
ipaddress
auth] {
hostname
}
source
source-ip
servername
name
222
Controlling Management Access
Purpose
Specify up to three keywords to exclude in a password. The
word
password does not accept the keyword in any form (in
between the string, case in-sensitive and reverse) as a
substring.
Verify the strength of a password during configuration.
Exit to Privileged EXEC mode.
View the configured settings for passwords.
View information about the last password configuration
attempt and whether it was successful.
Purpose
Enter Global Configuration mode.
Specify a RADIUS server host and enter RADIUS
| Configuration mode.
• acct | auth — The type of server (accounting or
authentication). If no type is specified, the type is
authentication.
ipaddress
•
hostname
•
(Range: 1–255 characters).
Specify the source IP address to be used for
communication with Radius servers. 0.0.0.0 is interpreted
as a request to use the IP address of the outgoing IP
interface.
Assign a name to a RADIUS server. The default RADIUS
server name is Default-RADIUS-Server.
— The RADIUS server host IP address.
— Host name of the RADIUS server host