Table of Contents
Advertisement
MULTISCR:
Select this mode to monitor the camera pictures.
In MULTISCR mode you can perform the following
monitoring operations:
1. Camera picture
• Single spot picture
• Multi spot picture
• Single spot picture sequence
• Quad picture sequence
• Still multi spot picture
• Multi spot picture zoom
The menu content is different depending on the
selected mode. (Compare MENU 1 OF 3 for MUL-
TIPLEX and MULTISCR mode below.) This is
described in more detail on the following pages.
* MENU 1 OF 3 *
DYNAMIC REC
ALARM BUZZER
ALARM OUTPUT
REC MODE
MULTIPLEX mode
* MENU 1 OF 3 *
AUTO RESET
ALARM BUZZER
ALARM OUTPUT
MULTISCR CH SET *
MULTISCR mode
4. Press the MENU button to return to monitoring.
• How to Operate the Menus
To select the desired item, press buttons 9-12
C C
A A
B B
,
,
). Each time you press a button, the cursor
moves to the parameter of the selected item.
To set or select the desired parameter of the select-
ed item, press button 13 ( ) or 14 (+).
Note:
Some items have a submenu (for example,
TITLE SETUP in MENU 2 OF 3). To make set-
tings in a submenu, press button 15 (SET).
Blinking
OFF
2S
2S
4FIELDS
Blinking
60S
2S
2S
(D D
,
A. Setting up MENU 1 OF 3 in
MULTIPLEX mode
The content of MENU 1 OF 3 in MULTIPLEX mode
is as shown below.
* MENU 1 OF 3 *
DYNAMIC REC
ALARM BUZZER
ALARM OUTPUT
REC MODE
1. DYNAMIC REC
When
ON
is
camera picture of a channel that receives an alarm
signal is recorded with more fields than normal. If
the alarm signal is received by multiple channels,
the pictures of all these channels are recorded.
1. Move the cursor to the DYNAMIC REC parameter.
9
10
2. Select ON or OFF.
ON: The video signal of the channel that receives
the alarm signal is recorded with more fields
than normal. If the alarm signal is received by
multiple channels, the pictures of all these
channels are recorded.
OFF: The video at field rate are recorded from
channels number 1 to 16 regardless of any
channels receiving the alarm signal.
The factory setting is OFF.
• If you do not change any other parameters, press
the MENU button for 2 seconds. The setup menu is
closed and the display returns to the monitoring
picture.
Before turning the power off, make sure to finalize
your settings by pressing the MENU button.
Otherwise the new settings will not be stored and
the previous settings remain in effect.
power off after the monitoring picture appears on
the display.
-8-
OFF
2S
2S
4FIELDS
selected for DYNAMIC REC, the
12
11
Turn the
Advertisement
Table of Contents
