Table of Contents
Advertisement
D. Still Multi Spot Picture
The following function is available in multi spot
picture mode only.
1. Set the MODE SELECT/CAMERA SELECT switch to
MODE SELECT.
2. Press the (STILL ON) button 16. The STILL ON indi-
cator lights.
3. Set the MODE SELECT/CAMERA SELECT to CAM-
ERA SELECT.
4. Press one of the camera selection buttons whose
indicator is lit.
The LED on the pressed button starts blinking and
the picture corresponding to that button appears
still on the monitor.
The word STILL appears blinking on the monitor
screen.
5. Press the camera selection button whose indicator
is blinking.
The selected picture is displayed again for normal
monitoring.
6. To release STILL ON mode, set the MODE SELECT/
CAMERA SELECT switch to MODE SELECT, then
press button 16 (STILL ON).
The STILL ON indicator goes out.
ENTRANCE
Normal Camera Picture
STILL
Still Picture
(The word "STILL" blinks)
Notes:
• If you press the camera selection button for a
camera whose picture is not displayed on the
monitor screen, the operation is ignored.
• The word "STILL" is not displayed if STILL/
ALARM DISP in MENU 2 OF 3 is set to OFF.
E. Zoomed Multi Spot Picture
The following function is available in multi spot
picture mode only.
1. Set the MODE SELECT/CAMERA SELECT switch to
MODE SELECT.
2. Press
the
ZOOM/MULTISCREEN/QUAD
button. The "+" sign appears in the picture.
Note: The "+" sign disappears if no operation takes
place within approx. 5 seconds.
3. Move the "+" sign to the picture you want to zoom
by pressing buttons 9-12
4. Press button 14 (+) to zoom in. To zoom out, press
button 13 ( ).
Notes:
• Each time button 14 (+) is pressed, the picture
is zoomed in. Zooming stops when it reaches
the maximum level.
• The picture cannot be zoomed out to be smaller
than the original size by pressing button 13 (–).
5. To move the picture, press buttons 9 - 12
C C
A A
B B
,
,
down, left, or right depending on the button
pressed. The picture will stop at the edge of
the monitor screen.
ENTRANCE
Notes:
• When you change the multiscreen pattern (for
example, quad to 3x3), the size of the zoomed pic-
ture is not the same even if the picture is from the
same channel.
• The title in the picture disappears when the
ZOOM/MULTISCREEN/QUAD
pressed. The title remains off the screen even after
the "+"• sign disappears.
To call the title back on the screen, quit the zoom
function and operate another function.
-21-
(D D
C C
A A
B B
,
,
,
).
). The zoomed picture will move up,
Normal Camera Picture
Picture with the "+" sign
Zoomed Picture
SHIFT
SHIFT
(D D
,
button
is
Advertisement
Table of Contents
