Rear System Fan Assembly; Removing The Rear System Fan Assembly; Installing The Rear System Fan Assembly - HP Z400 - Workstation Maintenance And Service Manual

Rear system fan assembly

This section describes how to remove and install the rear system fan assembly.

Removing the rear system fan assembly

To remove the rear system fan assembly:
1. Power down the workstation (see
2. Disconnect power from the workstation (see
3. Remove the side access panel (see
4. Disconnect the rear system fan assembly cable
figure.
Figure 5-25
5. Remove the four screws from the rear of the chassis
then up

Installing the rear system fan assembly

To install the rear system fan assembly, reverse these steps.
ENWW
Disconnecting fan wires
out of the chassis.
Predisassembly procedures on page
Predisassembly procedures on page
Removing the side access panel on page
from the system board as shown in the following
, and then pull the fan assembly inward and
2
69).
72).
Removing and installing components
69).
91