Side Access Panel; Removing The Side Access Panel; Installing The Side Access Panel - HP Z400 - Workstation Maintenance And Service Manual

Side access panel

Before accessing the internal components of the workstation, you must remove the side access panel.
This section describes how to remove and install the side access panel.

Removing the side access panel

To remove the side access panel:
WARNING!
powered off and that the power cord is disconnected from the electrical outlet.
1. Power down the workstation (see
2. Disconnect power from the workstation (see
3. Remove locks that are present such as a cable lock.
4. Pull up on the handle
cover off the chassis
Figure 5-4

Installing the side access panel

To install the side access panel:
1. Align the bottom groove of the side panel with the bottom edge of the chassis.
2. Rotate the side panel toward the chassis, slide the panel forward to engage the fingers on the top
cover as well as the latch, then press firmly until the latch engages.
72 Chapter 5 Replacing components
Before removing the workstation side access panel, be sure that the workstation is
, slide the cover 1/2-inch towards the rear of the system
as shown in the following figure.
Removing the side access panel
Predisassembly procedures on page
Predisassembly procedures on page
69).
69).
, then rotate the
2
ENWW