HP Z400 - Workstation Maintenance And Service Manual page 147

6. On the back of the front bezel, squeeze the HP logo mounting tabs
as shown in the following figure.
2
Figure 5-76
Rotate the HP logo 90 degrees counterclockwise, and then release the logo and press it back into
place in the front bezel.
7. Remove the EMI filler panels and remove the optical disk drive from the chassis (see
an optical disk drive from the optical bay (mini-tower configuration) on page
8. Rotate the EMI filler panels and the optical drive 90 degrees as shown in the figure below, and then
reinstall them (see
Figure 5-77
9. Replace the front bezel (see
(see Installing the side access panel on page
ENWW
Rotating the HP logo
Installing an optical drive (desktop configuration) on page
Reinstalling the optical drive
Installing the front bezel on page 75) and the side access panel
72) when finished.
Removing and installing components 135
and press the logo outward
Removing
80.
86.