Chapter 2
5. Insert six screws into the front of the hot-swap mass storage cage, as shown
in Figure 2-12, and tighten them.
Step 5: Remove Fan Assemblies
Before you install the SCSI cable, remove two fan assemblies to gain working
space and access to the SCSI B connector on the I/O board. The fan assemblies are
the same in the pedestal and rack configurations of the NetServer, but separate
instructions are supplied because the NetServers are oriented differently.
To remove the fan assemblies, follow the procedure for your NetServer
configuration:
HP NetServer in pedestal configuration
HP NetServer in a rack
For a Pedestal NetServer
Do the following to remove the fan assemblies from an HP NetServer in pedestal
configuration:
1. Disconnect the fan cables from the Fan 0 and Fan 1 connectors, shown in
Figure 2-13, on the system backplane.
Installation
21