Step 7: Connect Power Harness; Step 8: Replace Fan Assemblies - HP D5970A - NetServer - LCII Manual

Chapter 2

Step 7: Connect Power Harness

1. Orient the P2 power harness connector to the power connector on the
backplane of the mass storage cage, as shown in Figure 2-18.
Power Connector
on Cage
P2 on Power Harness
(Latch on Underside)
Figure 2-18. Connect Power Harness to Backplane of Mass Storage Cage
2. Connect the P2 on the power harness to the power connector on the
backplane of the mass storage cage. Verify that the latch is seated.

Step 8: Replace Fan Assemblies

The two fan assemblies are identical. Replace them as follows:
1. Insert the prongs of one fan assembly into the Fan 0 holes in the accessory
board guide, shown in Figure 2-19.
26
Installation
SCSI Cable