For A Netserver In A Compaq Rack - HP D5970A - NetServer - LCII Manual

Chapter 2

For a NetServer in a Compaq Rack

For an HP NetServer in a Compaq rack, refer to the NetServer documentation and
your rack documentation for instructions as you do the following to replace
Cover 1 and the front bezel:
1. Insert the tabs inside the rear edge of Cover 1 into the slots at the rear of
the NetServer chassis.
Figure 2-26. Replace Cover 1 on NetServer in Compaq Rack
2. Slide Cover 1 toward the rear of the NetServer, as shown in Figure 2-26.
3. Tighten the thumbscrew at the front of Cover 1.
Installation
35