HP D5970A - NetServer - LCII Manual page 55

Chapter 3
6. The Adapter Boot Order screen displays the two SCSI controllers and
numbers representing their boot order in the following form:
Boot
Order
A SYM53C895 01
where A and B are the numbers 0 or 1 or a blank.
The number in the A position indicates the boot order of the SCSI A
controller, and the number in the B position indicates the boot order of the
SCSI B controller.
0 marks the controller of the SCSI channel searched first for a bootable
drive.
1 marks the controller of the SCSI channel searched second for a
bootable drive.
A blank indicates that the controller's SCSI channel is not searched for
a bootable drive.
To add or change a boot order sequence number, use the right and left
arrow keys to highlight the controller, and then press ENTER. Type the
new sequence number (0 or 1), and press ENTER. The boot order sequence
number of the other controller will change, if necessary. 0 must be assigned
to a controller before 1 can be assigned to the other controller.
To remove a controller from the boot order, use the right and left arrow
keys to highlight the controller, and then press ENTER twice. (This creates
a blank.) The boot order sequence number of the other controller will
change to 0, if necessary.
7. Press ESC to return to the Main Menu. To begin to exit the utility, use the
up and down arrow keys to highlight Quit, and press ENTER. When the
message
Rebooting system to change global settings...
is displayed, press any key to exit the Symbios Configuration utility and
restart the NetServer.
Boot
Bus DevFunc Order
30 B SYM53C895 01
Press any key
Configure Mass Storage
Bus DevFunc
38
51