Set Ntp-Parameters - HP P2000 Reference Manual

set ntp-parameters

Description Sets Network Time Protocol (NTP) parameters for the system. Date and time values use Coordinated
Universal Time (UTC). You can manually set system date and time parameters by using the
controller-date
Syntax
set ntp-parameters
ntp enabled|disabled|on|off
ntpaddress IP-address
timezone +|-hh[:mm]
Parameters ntp enabled|disabled|on|off
Enables or disables use of NTP. When NTP is enabled and the specified NTP server is available,
each controller's time is synchronized with the server.
ntpaddress IP-address
The network address of an available NTP server.
timezone
The system's time zone as an offset in hours (- 1 to - 1 2, +1 to +13) and minutes (0–59) from UTC. For
example, the Pacific Time Zone offset is -8 during Pacific Standard Time or -7 during Pacific Daylight
Time.
Example Set the system to use NTP with an offset for Mountain Standard Time:
# set ntp-parameters ntp enabled ntpaddress 69.10.36.3 timezone -7
Success: Command completed successfully.
Set the system to use NTP with an offset for the Bangalore, India time zone:
# set controller-date ntp enabled ntpaddress 69.10.36.3 timezone +5:30
Success: Command completed successfully.
See also • set controller-date
• show controller-date
• show ntp-status
command.
+|-hh[:mm]
HP P2000 G3 MSA System CLI Reference Guide 147
set