Set Priorities - HP P2000 Reference Manual

set priorities

Description Sets snapshot-retention priorities for a specified snap pool. Snap-pool priorities, in conjunction with
snapshot priorities, determine which snapshots are retained if system resource limitations require
some snapshots to be automatically deleted.
The higher the priority value, the higher priority for retention of associated snapshots. Priority values
are 0–65535, where 0 specifies to use the parameter's default value.
Syntax
set priorities
[standard-snap #]
[volume-copy #]
[replication-snap #]
[replicating #]
[common-sync-point #]
[only-sync-point #]
[queued #]
snap-pool
Parameters standard-snap #
Optional. Retention priority for a standard snapshot. The default is 0x6000 (24576).
volume-copy #
Optional. Retention priority for a snapshot that is being used to copy data from a source volume to a
destination volume. This attribute is temporary for the duration of the volume-copy process. The
default is 0xa000 (40960).
replication-snap #
Optional. Retention priority for a replication snapshot. The default is 0x4000 (16384).
replicating #
Optional. Retention priority for a snapshot that is being replicated to a secondary volume. This
snapshot is required in order to resume the replication. The attribute is temporary for the duration of
the replication process. The default is 0xc000 (49152).
common-sync-point #
Optional. Retention priority for the latest snapshot that is copy complete on all secondary volumes. It
identifies a common point in time that is known by all destinations. The default is 0x8000 (32768).
only-sync-point #
Optional. Retention priority for the only sync point that is available on at least one secondary
volume. If this snapshot is removed, then the next replication requires a full sync to be performed. The
default is 0xe000 (57344).
queued #
Optional. Retention priority for a snapshot that was taken for remote replication but is queued
waiting for the previous replications to complete. The default is 0x2000 (8192).
snap-pool
Name or serial number of the snap pool.
Example Set attribute priorities for snap pool SnapPool1, raising the priority for standard snapshots and
leaving other priorities unchanged:
# set priorities only-sync-point 65535 SnapPool1
See also • show priorities
• show snap-pools
HP P2000 G3 MSA System CLI Reference Guide 149