show host-parameters
Description Shows information about host ports on both controllers. This command shows the same information
as the
show ports
Syntax
show host-parameters
Output Ports
Controller ID and port number
Media
•
FC(L): Fibre Channel-Arbitrated Loop
•
FC(P): Fibre Channel Point-to-Point
•
FC(-): Fibre Channel disconnected
•
SAS: Serial Attached SCSI
•
iSCSI: Internet SCSI
Target ID
Port WWN or IQN
Status
•
Up: Port is cabled and has an I/O link.
•
Disconnected: Either no I/O link is detected or the port is not cabled.
Speed (A)
Actual link speed in Gbit/sec. Blank if not applicable.
Speed (C)
Configured host-port link speed:
•
FC: Auto, 8Gb, 4Gb, or 2Gb (Gbit/sec)
•
iSCSI: Auto or 1Gb (Gbit/sec)
•
Blank if not applicable
Topo (C)
FC and SAS only. Configured topology.
Width
SAS only. Number of SAS lanes in the port.
PID
FC and SAS only. Primary ID, or blank if not applicable.
IP-Ver
iSCSI only. IP version: IPv4 or IPv6.
PIP
iSCSI only. Primary IP address.
PIP-Gateway
iSCSI only. Primary gateway IP address.
PIP-Netmask
iSCSI only. Primary subnet mask IP address.
MAC
iSCSI only. Unique Media Access Control (MAC) hardware address, also called the physical
address.
SIP
iSCSI only. Secondary IP address. This field is only displayed during failover.
command.
HP P2000 G3 MSA System CLI Reference Guide 203