HP D6030A - NetServer - E50 Getting Started page 11

Chapter 3
The system starts scanning for any connected tape drives. If it locates an
HP SureStore T20 tape drive, a message appears identifying it as an HP
T20 device.
3. Click the OK button to start installation of the device driver.
4. You need to install the driver from the drivers diskette you created in the
previous section or from the C: drive if you installed NT 4.0 from using
HP Installation Assistant.
If you are installing the drivers from a drivers diskette, insert the
diskette and click OK.
If you are installing the drivers from the C: drive, identify this
pathname: C:\HP\DRIVERS\T20.
When the driver is successfully loaded, the Tape Devices panel displays a
"driver loaded" message.
5. Close the Control Panel.
6. Install the Stac Replica backup software using the SETUP.EXE file. You
will find this file in one of two places:
If you installed NT 4.0 using HP Installation Assistant, the files
necessary to install Stac Replica were copied to your C: drive. Execute
the Setup utility from the following subdirectory:
C:\I386\$OEM$\STAC\SETUP.EXE
If you did not install NT 4.0 using HP Installation Assistant, insert the
HP SureStore Tape CD-ROM in the HP NetServer's CD-ROM drive.
Execute the SETUP.EXE file for the language you want to use:
For the English version, execute SETUP.EXE from the
\STAC\ENG_NT subdirectory.
For the French version, execute SETUP.EXE from the
\STAC\FRE_NT subdirectory.
For the German version, execute SETUP.EXE from the
\STAC\GER_NT subdirectory.
For the Spanish version, execute SETUP.EXE from the
\STAC\SPA_NT subdirectory.
7. Once the Setup utility is running, follow the onscreen instructions for
completing the installation.
Installing Replica
7