Finishing The Installation; Verifying The Replica Installation - HP D6030A - NetServer - E50 Getting Started

Chapter 3
For the German version, execute SETUP.EXE from the
\stac\ger_nwpa directory.
For the Spanish version, execute SETUP.EXE from the
\stac\spa_nwpa directory.
To install the DDFS version:
For the English version, execute SETUP.EXE from the \stac\eng_nw
directory.
For the French version, execute SETUP.EXE from the \stac\fre_nw
directory.
For the German version, execute SETUP.EXE from the \stac\ger_nw
directory.
For the Spanish version, execute SETUP.EXE from the \stac\spa_nw
directory.

Finishing the Installation

When the installation of Replica is complete, perform the following:
1. Update STARTUP.NCF through NetWare's INSTALL utility. Make sure
it contains the line:
SET RESERVED BUFFERS BELOW 16 MEG=200
2. Enable support for HP OpenView or HP TopTools. Add the following line
to AUTOEXEC.NCF just ahead of "LOAD REPLICA":
LOAD STACSDI –snmp
3. When the installation is complete, restart the server to load Replica.
When the HP NetServer restarts, Replica is ready for use.

Verifying the Replica Installation

If Replica is successfully installed on your HP NetServer, three program shortcuts
appear as icons on your desktop and the Replica application is available through
the Start menu, under the Replica Program Group. For more information on the
Replica shortcut icons, see the section, "Using Replica Shortcuts," in Chapter 4
of this guide.
12
Installing Replica