Attaching The Slides - HP D7171A - NetServer - LPr User Manual

Chapter 8
The slots in the mounting flange allow you to insert the flange in place behind
the outside face but in front of the bar nut.
Hold the bar nut behind the outside face of the column at the slide screw holes
marked earlier. Start (but do not tighten) two screws through the face of the bar
nut. Install the bar nuts on all four rack columns.
The mounting flanges are then positioned behind the column face, but in front of
the bar nuts.

Attaching the Slides

The slides have mounting flanges at each end (see Figure 8-6). The mounting
flange is inserted between the column and the bar nut.
Installing the NetServer in an HP Rack System/E or Rack System/U
Figure 8-5. How to Attach Bar Nuts
51