Error Messages; Post Error Codes - HP D7171A - NetServer - LPr User Manual

Chapter 12
h. Turn on the server.
i. Check for error messages.
4. Copy DiagTools from the HP NetServer Navigator CD-ROM to diskette,
and run it from diskette.

Error Messages

If you get an error message, insert your HP NetServer Navigator CD-ROM into
the CD-ROM drive and press the Reset button on the front of the NetServer. An
error message utility will automatically display the error message and a possible
solution.
For a complete list of error messages and solutions see the NetServer Information
Assistant program on the HP NetServer Online Documentation CD-ROM.

POST Error Codes

Refer to this list if error codes appear after the NetServer is powered on.
Table 12-1. POST Error Codes
Code Message
00B00h Missing Microcode Update data block for Pentium II CPU
00B0lh Missing Microcode Update data block for Pentium II CPU
00Bl0h Failure Loading Microcode Update data block for Pentium II CPU
00Bllh Failure Loading Microcode Update data block for Pentium II CPU
00B20h Defective Microcode Update data block for Pentium II CPU
00B2lh Defective Microcode Update data block for Pentium II CPU
00090h DIMM management failure
00080h HP NetServer Management Controller Selftest Failure
00510h IDE Device #0 Error
00l00h Keyboard Error
00l0lh Keyboard Error
00012h Incorrect System Configuration
000llh Date and Time Lost
00300h Flexible Disk Drive A Error
00301h Flexible Disk Drive B Error
Troubleshooting
89