HP LC2000r - NetServer - 128 MB RAM Installation Manual page 39

Chapter 3
Figure 3-2. Removing the HP NetServer LH 6000r Bezel
3. Do not unscrew the entire hinge or bracket from the NetServer. Use a
Torx 25 screwdriver to remove only the four outer screws so that the hinge
and the bracket remain attached to the NetServer chassis as shown in
Figure 3-3.
Remove two
screws securing
the NetServer
to the rack.
Do not remove
three screws
securing the
hinge to the
NetServer.
Figure 3-3. Front of LH 6000r - Screw and Cover Locations
Opening and Closing the HP NetServer
Top Cover
Bottom Cover
Remove two
screws securing
the NetServer
to the rack.
Do not remove
two screws
securing the
bracket
to the NetServer.
Right Cover
31