Installing The Netserver - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 8 Installing the HP NetServer in an HP Rack System/E or Rack System/U

Installing the NetServer

The following steps require lifting the HP NetServer with the mounting handles
and sliding the slide members through the handles to secure it to the slides
installed in the rack.
WARNING Extend the anti-tip foot from under the front of the rack or
insure that the anti-tip feature is installed and lower all leveler
feet to stabilize the rack before mounting rack components.
Failure to use the anti-tip foot/device and leveler feet could
result in serious injury.
1. Lower the four rack leveler feet to the floor, lifting the rack off the rack
wheels (see Figure 8-9).
2. Fully extend the anti-tip foot from the front of the rack.
Lower
leveler feet.
Figure 8-9. Preparing the Rack for HP NetServer Installation
3. Extend the slides until you hear a click, indicating they are locked.
Lockout
Latch
Extend slide
members until
they lock.
Lockout
Latches
Extend
anti-tip foot.
89