HP LC2000r - NetServer - 128 MB RAM Installation Manual page 53

Chapter 4
Figure 4-5. Hot-Swap Drive and Filler Panel
CAUTION When installing more than one drive, do not stack drives on
your work surface. Hard disk drives are very susceptible to
mechanical shock and can be damaged by a drop as short as
one-quarter of an inch. Take care when unpacking and
handling the drive. If the drop would crack an egg, it will
damage the drive.
2. Drive spacers attach to the disk drive module with four small feet.
If you need to remove a drive spacer from a disk drive slot:
Slide the drive spacer back, a fraction of an inch away from your body.
Tilt up the front of the drive spacer to disengage the front two feet.
Pull the drive spacer forward slightly to disengage the back two feet
and lift (see Figure 4-6).
Installing Mass Storage Devices
45