Attaching The Cable Management Arm - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 8 Installing the HP NetServer in an HP Rack System/E or Rack System/U
7. Slide the anti-tip foot into the rack.
8. Return to the HP NetServer Rack Installation Road Map to complete the
rack installation.

Attaching the Cable Management Arm

The Cable Management Arm for the HP NetServer LH 6000r can only be
mounted on HP Systems racks. The HP NetServer Cable Management Arm allows
the cables, including the power cords, to move in and out with the HP NetServer
chassis on its slides without being accidentally disconnected (see Figure 8-17).
WARNING Before sliding out the HP NetServer, ensure the anti-tip foot
from under the front of the rack is extended or the anti-tip
feature is installed. A tip-over hazard exists, so never slide
more than one component out of the rack at a time.
1. Ensure the HP NetServer is pushed all the way into the rack.
2. At the rear of the NetServer, place rack nuts on the left column in the 17th
and 18th holes above the baseline of the HP NetServer (see Figure 8-17).
Figure 8-16. Installing the Bezel
95