Sharp FO-1470 Service Manual page 7

3
Take the new film out of its package, and insert two of the gears
provided with the fax into the ends of the spool with film. Make sure
that the two tabs on the gears fit properly into the slots in the ends of
the spool.
•
Do not yet remove the band which holds the spools together.
2 tabs
4
Hold the empty spool so that the end with only one slot is on the left,
and lower the spools into the front of the printing compartment. The
gears in the ends of the spool with film should fit into the slots on
each side of the printing compartment.
5
Cut the band which holds the spools together with scissors, and re-
move it. Insert the remaining gear into the right end of the empty
spool and the flange into the left end of the empty spool. Make sure
the tabs on the gear and the flange fit into the slots in the ends of the
spool (the gear has two tabs and the flange has one tab).
1 tab
Flange
6
Pull the empty spool toward the back of the compartment, unwind-
ing the film as you pull.
7
Insert the empty spool into the back of the compartment so that the
gear and the flange fit into the slots on the sides of the compartment.
•
8
Wind the film slightly (rotate the gear on the right side of the empty
spool) so that there is no slack in the film. Make sure that both edges
of the film wind onto the spool evenly.
9
Close the print compartment cover, making sure it clicks into place.
•
2 tabs
Gear
F
Load paper in the paper tray and then press the following keys to
initialize the film.
Note: Paper must be loaded before the film can be initialized. To load
paper, see Loading the Printing Paper.
FUNCTION
When to replace the imaging film
1 – 5
Make sure that the gear engages with the gear below it.
Caution! Close the cover slowly to make sure it doesn't pinch your
fingers.
Display shows:
6
INITIALIZE FILM
Replace the imaging film when the display shows:
FILM END
Use the following imaging film, which is available from your dealer
or retailer: Sharp UX-15CR/FO-15CR Imaging Film
•
Caution! The text of documents printed with the imaging film is
visible on the used film. If confidential information has
been printed, dispose of the film appropriately.
UX-510UA
FO-1470U
START